BPQ32 at Yahoo! Groups

Re: Pactor Testing

Jack Chomley — Mon, 23 Nov 2009 21:21:01 GMT

... John, IF you are considering doing the code for one of these..... http://www.scs-ptc.com/shop/products/modems/tracker-dsp-tnc I have one I can loan you,

Re: Pactor Testing

Jerry - N9LYA — Mon, 23 Nov 2009 20:47:51 GMT

Hi John.. I have one I am using part time.. Tell me how to put it on a serial tunnel and I will make it happen. Jerry _____ From: BPQ32@yahoogroups.com

Re: Pactor Testing

Richard — Mon, 23 Nov 2009 18:17:16 GMT

I have a ptc-IIex available... contact me at ke7xo@... Richard ... From: John Wiseman To: BPQ32@yahoogroups.com Sent: Monday, November 23, 2009 9:47 AM

Pactor Testing

John Wiseman — Mon, 23 Nov 2009 17:50:31 GMT

Hi Folks, I'm working in a PACTOR interface for BPQ32, but I don't have a SCS Controller to to test with. I wonder if anyone has a spare controller they could

Re: DSTAR - was PROTOCOL=KISS PROTOCOL=NONE?

la7um — Mon, 23 Nov 2009 04:37:08 GMT

One problem may be that D-Star has no HW handshake. So the nullmodem cable transpoorting is only a tx, rx and ground, needing Xon , Xoff software handshake. I

Re: BPQ32_4.10L_2009Nov22 is available for download

Mark Harloff — Mon, 23 Nov 2009 00:33:35 GMT

Will install here after the contest is over. Too much activity on the cluster to shut down right now. - Mark K2CAN

Re: BPQ32_4.10L_2009Nov22 is available for download

Jerry - N9LYA — Sun, 22 Nov 2009 23:45:49 GMT

Same here!!! 73 Jerry N9LYA ... From: BPQ32@yahoogroups.com [mailto:BPQ32@yahoogroups.com] On Behalf Of K.O. Higgs Sent: Sunday, November 22, 2009 6:37 PM To:

Re: BPQ32_4.10L_2009Nov22 is available for download

K.O. Higgs — Sun, 22 Nov 2009 23:37:24 GMT

Installed.. running fine. K.O. N0KFQ ... -- K.O. Higgs n0kfq@...

BPQ32_4.10L_2009Nov22 is available for download

n5in_ron — Sun, 22 Nov 2009 19:48:49 GMT

The latest release of BPQ32 is now available for download at: http://groups.yahoo.com/group/BPQMailChat/ and http://groups.yahoo.com/group/BPQ32/ It includes

Re: DSTAR - was PROTOCOL=KISS PROTOCOL=NONE?

Bill V WA7NWP — Sun, 22 Nov 2009 17:48:06 GMT

... Note that this "serial stream" the D-Star provides has no "packeting" or error detection.. I believe the D-Rats scheme was to build the D-Star

Re: DSTAR - was PROTOCOL=KISS PROTOCOL=NONE?

Howard Z — Sat, 21 Nov 2009 15:42:29 GMT

John is of the opinion that if D-Star radios will pass all bytes without any modification nor filtering, then there is no need for BPQ changes. If the two

Re: DSTAR - was PROTOCOL=KISS PROTOCOL=NONE?

la7um — Sat, 21 Nov 2009 03:17:51 GMT

Howard. You kind of touch the same question I did ask some days ago on the new Winlink Programs reflector. Good. A "RMS DStar DV"is of value. Maybe John can

Re: DSTAR - was PROTOCOL=KISS PROTOCOL=NONE?

Jerry - N9LYA — Thu, 19 Nov 2009 09:57:02 GMT

Null Modem Cable.. http://www.jameco.com _____ From: BPQ32@yahoogroups.com [mailto:BPQ32@yahoogroups.com] On Behalf Of Howard Z Sent:

Re: DSTAR - was PROTOCOL=KISS PROTOCOL=NONE?

Howard Z — Thu, 19 Nov 2009 04:33:40 GMT

I'll try again next week. I'll have to see about getting the right cable. 9pin female to female with pins 2 and 3 reversed. Howard

Re: DSTAR - was PROTOCOL=KISS PROTOCOL=NONE?

John Wiseman — Tue, 17 Nov 2009 15:44:35 GMT

Howard, Did you try it with a serial cable between the machines, to make sure the setup is correct? The message exchange is likely to be compressed so will