Excelsior-Henderson-Resource-Board at Yahoo! Groups

Re: Rally plans...

Jumper — Sat, 04 Jul 2009 10:15:55 GMT

Geez Randy... They musta been on the other side of the party... See any nekid wimmin?? Jumper

Re: Rally plans...

Randy — Sat, 04 Jul 2009 01:12:44 GMT

Rally plans...

Jumper — Fri, 03 Jul 2009 22:44:24 GMT

While all the Mid-West Xer's are down in Iowa hootin and hollerin... Other Xer's are getting ready to hit the road.... Humph.... Jumper

Re: Brake light not working

Jumper — Fri, 03 Jul 2009 22:36:48 GMT

Try cleaning the rear brake switch before replacing. Clean the terminals and make sure they fit tight. Check your brakefluid level too. Might put "rotating"

Re: Transmission grinding going into first gear

xj6sovereign@... — Fri, 03 Jul 2009 21:57:57 GMT

Hi Doug, The motor wasn't warmed up so maybe that didn't help. Bobby worked on the bike last July but didn't do the trans at least not then. I spoke to him and

Re: Transmission grinding going into first gear

Douglas Riggs — Fri, 03 Jul 2009 21:25:03 GMT

That is some amount of noise ________________________________ From: Douglas Riggs To:

Re: Transmission grinding going into first gear

Douglas Riggs — Fri, 03 Jul 2009 21:21:59 GMT

If it has only got that many miles you had better not run synthetic til it is broke in. Some amount of some is quite normal, especially if it is not warm up.

Re: Brake light not working

xj6sovereign@... — Fri, 03 Jul 2009 20:43:02 GMT

Thanks Jumper, The front switch looks like a piece is missing that the brake lever activates, so I'll replace that. I found the rear brake light switch and

Re: Transmission grinding going into first gear

xj6sovereign@... — Fri, 03 Jul 2009 20:35:37 GMT

Van, Thanks for all your effort, that was very nice of you. I'll probably change the oil as you suggested with a good full synthetic oil and see if that helps.

Re: Transmission grinding going into first gear

Jumper — Fri, 03 Jul 2009 20:32:23 GMT

Check the engine oil since it's all the same oil. Run it at the second X. Make sure you understand how to check the oil.. Jumper

Re: Brake light not working

Jumper — Fri, 03 Jul 2009 20:29:31 GMT

Joe.. Two brake light switches... Front brake..micro switch on handle bar that needs cleaning sometimes... Rear brake light switch behind engine low in front

Re: Transmission grinding going into first gear

William Brann — Fri, 03 Jul 2009 20:25:45 GMT

Joe, I checked with Marty(Superxparts.com) to see if Jamie might have done your trany. Jamie did do #437 & #438 but not #436. You could check with John Jones

Transmission grinding going into first gear

xj6sovereign@... — Fri, 03 Jul 2009 17:45:31 GMT

Hello again, I haven't driven the bike yet but I noticed the transmission grinds a little when you go from neutral to first gear. It doesn't seem to grind

Re: Joe - Super-X 436

xj6sovereign@... — Fri, 03 Jul 2009 17:36:53 GMT

Thanks for that link. The strange thing is the bikes colors are green/oyster, not blue as mentioned. It does have a non-stock headlight though, I have'nt

Re: X'ers at the rally in Algona

Randy — Fri, 03 Jul 2009 17:29:16 GMT