HaltechSupport at Yahoo! Groups

no subject

Rusty Elrod — Wed, 13 Mar 2013 12:54:37 GMT

http://www.northdallastherapist.com/ftqkrs/khfvrt.htm

Re: Passing Smog in CA with half-bridged RX-7

waltersaegir — Fri, 30 Nov 2012 02:08:39 GMT

What about propane, natural gas conversions?

Passing Smog in CA with half-bridged RX-7

waltersaegir — Fri, 30 Nov 2012 01:26:10 GMT

What could make this possible? My '88 Convertable is modified. Short of replacing the engine, what could clean the exhaust enought to pass smog here in

Re: Questions about E6k and Toyota 4AGE

waltersaegir — Fri, 30 Nov 2012 01:11:37 GMT

Does this infer that your half-bridged RX-7 passed smog? I'm going to open another thread to address my need to get my own half-bridged to pass smog here in

(no subject)

Rusty Elrod — Fri, 12 Aug 2011 20:59:45 GMT

http://industrial-buy.com/efoeh.htm

(no subject)

Rx7turboii — Sat, 06 Aug 2011 10:02:57 GMT

http://shop.brall.biz/webshop/admin/backups/work.php?html72

Re: Best port for vacuum signal

Brian D. Cain — Sun, 08 May 2011 15:31:53 GMT

Those in back will work just fine. Generally the best places to find a reference source for MAP/FPR are just aft of the throttle body in the surge plenum of a

Best port for vacuum signal

turborotor87 — Sun, 08 May 2011 06:46:16 GMT

Hello everyone, I've been out of the scene for quite some time, like 4 yrs. Finally getting my FC ready to fire up again but I'll be using a 13B RE engine. I

Re: Electronic Fuel Injection

Horatio Williams — Sat, 19 Feb 2011 14:22:27 GMT

Visit the Haltech website and find the a dealer that is nearest to you. If you buy the unit from them, you'll get all the support you need. ... From:

Re: Electronic Fuel Injection

Albe — Sat, 19 Feb 2011 13:44:32 GMT

www.efi101.com http://www.efituningtech.com/ and calibratedsuccess.com these are some fine schools that can get you going in the right path. They have forums

Electronic Fuel Injection

santi_salinas — Sat, 19 Feb 2011 12:16:53 GMT

I am a auto-electrician and I needed some information regarding electronic fuel injection to where i can get some technical information and troubleshooting of

GM TPI base map?

jeff — Tue, 15 Feb 2011 03:37:44 GMT

Hi guys. Im new to the Haltech ecu. Im looking for a base map for a 90 tpi corvette. Just something to get the car running and then we can go from there. I

Hello

Alberto Correa, Jr. — Sat, 21 Aug 2010 23:21:35 GMT

Hello I have found a supplier,which retail and wholesale. They provide cell phones, laptops, digital cameras and television and so on. If you buy a lot, more

Re: e6x firmware

amazing42 — Tue, 27 Apr 2010 02:49:15 GMT

... i had a bad distributor. :(

e6x firmware

amazing42 — Mon, 12 Apr 2010 03:57:21 GMT

because of the ecu acting inconsistently even in a basic attempt to get the car to idle i have concluded that there is either a hardware or software issue with