http://finance.groups.yahoo.com/group/K2CNC/ K2 CNC Wed, 30 Sep 2009 17:20:56 GMT wudtrnr4u http://finance.groups.yahoo.com/group/K2CNC/message/11 http://finance.groups.yahoo.com/group/K2CNC/message/11 I purchased a K1414 from K2CNC I am going to use it for routing . I was running road runner program and program keeps hitting limits .I am just know printing Tue, 08 Sep 2009 02:12:43 GMT master.unit http://finance.groups.yahoo.com/group/K2CNC/message/10 http://finance.groups.yahoo.com/group/K2CNC/message/10 I have bought a KG-9850-Rack-n-Pinion used and built a wooden table for it. At this point everything works fine. All the stop switches, the router, the gantry Tue, 28 Jul 2009 17:24:17 GMT bojnourd_65 http://finance.groups.yahoo.com/group/K2CNC/message/8 http://finance.groups.yahoo.com/group/K2CNC/message/8 hi i want buy hexapod cnc but i dont know how plz i need information about hexapod Thu, 04 Jun 2009 19:33:53 GMT Jacob Christ http://finance.groups.yahoo.com/group/K2CNC/message/6 http://finance.groups.yahoo.com/group/K2CNC/message/6 I couldn't say which is better stepper or servo since there are many factors that dictate better. The main advantages of servos over steppers is that servos Thu, 04 Jun 2009 19:22:00 GMT Jacob Christ http://finance.groups.yahoo.com/group/K2CNC/message/5 http://finance.groups.yahoo.com/group/K2CNC/message/5 I couldn't say which is better stepper or servo since there are many factors that dictate better. The main advantages of servos over steppers is that servos Thu, 04 Jun 2009 10:43:16 GMT midden300 http://finance.groups.yahoo.com/group/K2CNC/message/4 http://finance.groups.yahoo.com/group/K2CNC/message/4 ... thanks that was very helpful midden300 Tue, 02 Jun 2009 00:32:47 GMT tarik_pub http://finance.groups.yahoo.com/group/K2CNC/message/3 http://finance.groups.yahoo.com/group/K2CNC/message/3 ... i have k2 controle box, with servos.the motors work fine, good torque. i can't tell you better than steppers or not, i don't have much experience in Wed, 20 May 2009 11:14:01 GMT midden300 http://finance.groups.yahoo.com/group/K2CNC/message/2 http://finance.groups.yahoo.com/group/K2CNC/message/2 does anyone have the k2 control box with servo motors if so how well does the servo motors perform. and do you think they are better choice than stepper motors Wed, 04 Feb 2009 12:58:18 GMT Chuck http://finance.groups.yahoo.com/group/K2CNC/message/1 http://finance.groups.yahoo.com/group/K2CNC/message/1 easiest way too set stop limits on my KT1414,.