http://autos.groups.yahoo.com/group/dmcnews/ DML - the DeLorean Mailing List Fri, 09 May 2008 11:19:47 GMT bitsyncmater http://autos.groups.yahoo.com/group/dmcnews/message/75699 http://autos.groups.yahoo.com/group/dmcnews/message/75699 I had the same problem of no Lambda/FV power but it was caused by the relay had not been aligned (soldered) properly when the RPM relay was built. I don't see Fri, 09 May 2008 11:19:37 GMT welmoedj http://autos.groups.yahoo.com/group/dmcnews/message/75698 http://autos.groups.yahoo.com/group/dmcnews/message/75698 I am very interested to know what the average daily mileage is that is usually planned by D owners. Though I have been in the US before, this will be the first Fri, 09 May 2008 11:19:18 GMT Elvis http://autos.groups.yahoo.com/group/dmcnews/message/75697 http://autos.groups.yahoo.com/group/dmcnews/message/75697 Hey Mike, I'm sorry to jump in this late, but I thought the RPM-relay is one of the first things you checked when playing with that circuit ?!?! Those are Fri, 09 May 2008 11:19:08 GMT Jake Kamphoefner http://autos.groups.yahoo.com/group/dmcnews/message/75696 http://autos.groups.yahoo.com/group/dmcnews/message/75696   Wow!  I never thought the light bulb question would generate so much interest.  Here's the scoop:   Kayo asked for the bulb that is on all the time.  Fri, 09 May 2008 11:18:55 GMT John Hervey http://autos.groups.yahoo.com/group/dmcnews/message/75695 http://autos.groups.yahoo.com/group/dmcnews/message/75695 Farrar, Mine will read the correct oil pressure if you have any oil pressure none, low or high. Don't blame the gauge if there is the wrong oil in the car and Fri, 09 May 2008 11:18:34 GMT John Hervey http://autos.groups.yahoo.com/group/dmcnews/message/75694 http://autos.groups.yahoo.com/group/dmcnews/message/75694 With the correct oil 20/40 or 20 /50 and the right oil pressure gauge that I sell and the idle at 900 or so you will normally hold about 30 to 40 lb's hot at Fri, 09 May 2008 11:18:06 GMT Dave Swingle http://autos.groups.yahoo.com/group/dmcnews/message/75693 http://autos.groups.yahoo.com/group/dmcnews/message/75693 About 45 degrees from where the slack is out of it, with the door open. Dave S ... torsion bar ... how ... trial and error ... it. Thanks Fri, 09 May 2008 11:17:57 GMT David Teitelbaum http://autos.groups.yahoo.com/group/dmcnews/message/75692 http://autos.groups.yahoo.com/group/dmcnews/message/75692 A bit less than 90 degrees. You will make several adjustments. Try not to have the doors "bounce" when opening. David Teitelbaum vin 10757 ... torsion bar ... Fri, 09 May 2008 11:17:46 GMT cbl1739 http://autos.groups.yahoo.com/group/dmcnews/message/75691 http://autos.groups.yahoo.com/group/dmcnews/message/75691 Same old same old, Unless you have never been there before(Disney world) they barely change anything went there in 1987 went again in 2007...same old stuff...I Fri, 09 May 2008 01:00:58 GMT Jason Rowe http://autos.groups.yahoo.com/group/dmcnews/message/75690 http://autos.groups.yahoo.com/group/dmcnews/message/75690 Hello all, I'm getting ready to install the new passenger side torsion bar and was wondering if anyone could give me a good starting point on how far to crank Fri, 09 May 2008 01:00:50 GMT mike clemens http://autos.groups.yahoo.com/group/dmcnews/message/75689 http://autos.groups.yahoo.com/group/dmcnews/message/75689 Elvis & Bob, You two are to be congratulated, Bob for coming up with the fix, and Elvis for your wonderful pictures. That should save some folks a nice bit of Fri, 09 May 2008 01:00:41 GMT mike clemens http://autos.groups.yahoo.com/group/dmcnews/message/75688 http://autos.groups.yahoo.com/group/dmcnews/message/75688 Group, Okay, either I'm the unluckiest guy I know, or Josh's car just plain hates me. For the second time, I have run across something I have never seen or Fri, 09 May 2008 00:59:50 GMT wingd2@... http://autos.groups.yahoo.com/group/dmcnews/message/75687 http://autos.groups.yahoo.com/group/dmcnews/message/75687 Guys, For those that are interested, a group of 12 or so Deloreans will be leaving the St Louis area on Tuesday morning, June 10th for the trip to Gettysburg. Fri, 09 May 2008 00:58:26 GMT Farrar Hudkins http://autos.groups.yahoo.com/group/dmcnews/message/75686 http://autos.groups.yahoo.com/group/dmcnews/message/75686 Drat, the previous owner replaced a not-so-great part with another not-so-great part. :P Is the one Maier sells the same as the one Hervey sells? (Reference: Thu, 08 May 2008 20:48:16 GMT fluxat88mph http://autos.groups.yahoo.com/group/dmcnews/message/75685 http://autos.groups.yahoo.com/group/dmcnews/message/75685 Hello all, I just wanted to remind all of you out there that this Sat is the BBQ and TECH session out at my place on the 10th. I already have several RSVP's